When you build an open back dollhouse it is wise to think out a scheme for installing a see through piece of plastic or glass to act as a dust cover. If you can somehow integrate it into the structure so that it is not visually intrusive that is best.
I just finished making the most complex timber I had to cut. It is a beam that goes against the floor beams of the attic. On the bottom is a rabbet to receive the upper edge of the dust cover from the first floor opening. On the top there is a channel to accept the bottom of the upper story dust cover. The timbers at the sides of the opening also have a rabbet for the dust cover to recess into. This way the cover won't project from the back of the dollhouse and all the edges of the plastic or glass are protected. I will make a small turn button to fix it into place but still allow it to be easy to remove.
 |
| photo copyright Karin Corbin 2010 |
This one piece timber plays a trick, on the top side it integrates into the flooring of the attic with a smooth surface that will match the floor stain color. But on the other three sides it is one of the structural timbers of the house. The timber is notched to allow the walls to slide into it. A lot of tricky cuts, the table saw did the rabbet and channel, the bandsaw made the receiving notches for the walls. I textured the surfaces that act as a framing piece.
Lots of timbering to do today on the inside walls of the dollhouse. The pieces around the opening are part of that job.
I will start gluing some of the walls in place today. The front wall will be the last to install as it is easy to see and reach from the back opening.
