Proxxon Miter Saw Fence

photo copyright Karin Corbin 2009

The Proxxon KGS80 Miter Saw is a very nice size for many task when scratch building a dollhouse. Not for the tiny strip wood pieces but great for things like window and door frames, flooring strips and such. However as it is out of the box it is going to launch any small pieces you cut all the way across the room. It is a powerful saw for its size. Good luck finding anything small in the back room of my workshop and of course the parts can be damaged by the journey and landing.

To make repetitive cuts of strips of wood an easier task I built a fence out of hardwood. Now my cut off pieces stay right there on the fence and I don't have to go hunting for them. My custom fence is sized to fit into the existing clamp on the saw. I did not want to modify the miter saw as it is very good for cutting pieces of non ferrous metals in it's standard configuration. The fence is a piece of 3/4" thick poplar wood that is cut to fit into the clamp opening. It is a little tricky to fit the fence in under the motor and on into the clamp, you will have to mess around with the design making adjustments as you go. Do worry a great deal about getting the fence on the back nice and square to the saw blade so it makes perfect 90 degree cut.

I had not used the saw for a while as I knocked off part of the back fence during the move last year. But since I had been ripping strips of hardwood and had plenty of extra it was a quick repair with that rubbery superglue. Now I am back in action again, whew, that feels good. I really like this saw.

If you are going to make a setup like this for your saw keep in mind that the rear wood fence needs to be short enough for the motor of the saw to come all the way down. Look at the photo, you will see the approximate height you need.

photo copyright Karin Corbin 2009

I made my fence base so it extended out further to the left so I can clamp on stop blocks. A long stop block will reach in quite a ways towards the center.

It is very important for your safety that you need to know the correct way to use miter saws with stops. You must secure the wood you are cutting some place between the saw blade and the stop block. If you don't the wood will get into a pinching situation and the part can be damaged and so can you.  Sometimes there is room for your fingers to do the clamping but don't take foolish risks. The eraser end of a pencil gets where fingers won't but sometimes even that is too big.  You can make other kinds of  custom hold down pieces as needed. When it is impossible to get in there with any kind of a clamp make a removable stop. Secure the work on the other side of the blade instead where you can get a grip on it.

You can find out more information on the Proxxon KGS80 by clicking "HERE"